The DHS Program User Forum: Weighting data

Home » Data » Weighting data » weighting data

Show: Today's Messages :: Show Polls :: Message Navigator

Re: weighting data [message #1414 is a reply to message #757]

Sun, 23 February 2014 17:45

Trevor-DHS
Messages: 808
Registered: January 2013

Senior Member

1) You can use the following to set up your survey design, stratification and weighting:

gen psu=v021
gen strata=v023
gen weight=v005/1000000
svyset psu [pweight=weight], strata(strata)

Note that the strata can vary from survey to survey and may not always be v023. In many surveys the strata are urban and rural areas within each region and can be produced with
egen strata = group(v024 v025), label
However, for the Bangladesh 2007 this would be incorrect as the strata are not just urban and rural areas in each region. See Appendix A of most final reports for information on the stratum used in selecting the sample. In this survey, v023 contains the 22 strata used for the stratification of the sample.

2) Yes, you should use svy in the subsequent commands.

Report message to a moderator

[Message index]

		weighting data By: jn2255 on Wed, 11 September 2013 14:38
		Re: weighting data By: Trevor-DHS on Sun, 23 February 2014 17:45
		Re: weighting data By: lhuri on Sun, 21 December 2014 05:46
		Re: weighting data By: Trevor-DHS on Fri, 26 December 2014 11:21
		Re: weighting data By: Alfi Lailiyah on Thu, 26 May 2016 03:29
		Re: weighting data By: Bridgette-DHS on Mon, 06 June 2016 08:09

Previous Topic:	Weighting in pooled data
Next Topic:	Weighting Data for Pooled Indonesian DHS Dataset

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 10 09:04:37 Coordinated Universal Time 2025